Armacell Product Selector

Tundra SS

Tube Insulation

Tundra® SS closed-cell polyethylene foam self-seal pipe insulation is used in residential and light commercial plumbing projects to prevent heat loss and protect pipes from freezing. It is available in wall thicknesses of 3/8" to 1” in sizes ranging from 3/8" up to 4" IPS ID.

Tundra SS is available to the trade in 6’ lengths and also sold in limited sizes through retail stores across North America. Tundra SS has a low thermal conductivity and very low water vapor transmission rate. This low density product demonstrates excellent thermal, physical and chemical resistant properties and has a broad service temperature range between -297°F and 200°F (-183°C and 93°C). It can be installed in residential and light commercial plumbing projects. It is acceptable for use with heat tracing/heat tape.

Overview

Tundra® SS closed-cell PE foam self-seal pipe insulation is used in residential and light commercial plumbing projects to prevent heat loss and protect pipes from freezing. Tundra SS has an integrated self-sealing system that makes it quick and easy to install. This product is also sold in limited sizes through retail stores across North America.

Product Advantages

  • Available in a wide range of pipe sizes and thicknesses

  • Indoor Air Quality: Low VOC, fiber-free, non-particulating, formaldehyde-free insulation

  • ASTM E 84 / CAN ULC S102.2 25/50 rated

  • Reduces plumbing noise

  • Resists mold and mildew

  • Cost effective

  • Speeds up installation time

  • Easy-to-install self-seal closure

  • Made in Canada

Application Areas

  • Domestic hot and cold water lines

  • Domestic heating and plumbing line

  • Acceptable for use on PEX

  • Acceptable for use with heat tracing/heat tape

Specifications

Specifications

  • Dark gray flexible PE thermal insulation in tubular form with semi-slit perforation for easy opening

  • ASTM C-1427, Type 1

  • ASTM E 84 / CAN ULC-S102.2 1” 25/50

  • NFPA 90 A/B / Acceptable for use in duct/plenum applications

Sizes:

  • Wall thicknesses (nominal) 3/8”, ½”, ¾” and 1”

  • In sizes 3/8” to 4” IPS

  • Lengths: 6’ lengths (3’ lengths sold in some retail stores)

  • For complete Specification and R-Value details, download the product submittal sheet.

For complete Specification and R-value details, download the product submittal sheet.

Accessories

  • ArmaFlex 520 and 520 Black Adhesive – Air-drying, solvent-based contact adhesive for strong bonds and tight seams.

  • AP ArmaFlex Insulation Tape

  • ArmaFlex Black LapSeal Tape

Armacell Manufacturing Locations

Did you know?

Armacell has 5 manufacturing facilities in the US and 1 in Canada. That means almost any product you order in North America is made in North America. Some exceptions apply.

Made In USA

2018 © Armacell LLC • 55 Vilcom Center Drive • Suite 200  • Chapel Hill, NC 27514 • tel 800 866 5638 • email: info.us@armacell.com