Armacell Product Selector

Tundra

Tube Insulation

Tundra® closed-cell polyethylene foam semi-slit pipe insulation is used in residential and light commercial plumbing projects to prevent heat loss and protect pipes from freezing. It is available in wall thicknesses of 3/8" to 1” in sizes ranging from 3/8" up to 4" IPS ID. Tundra is available to the trade in 6’ lengths and also sold in limited sizes through retail stores across North America.

Tundra has a low thermal conductivity and very low water vapor transmission rate. This low density product demonstrates excellent thermal, physical and chemical resistant properties and has a broad service temperature range between -297°F and 200°F (-183°C and 93°C). It can be installed in residential and light commercial plumbing projects. It is acceptable for use with heat tracing/heat tape.

Overview

Tundra® closed-cell PE foam semi-slit pipe insulation is used in residential and light commercial plumbing projects to prevent heat loss and protect pipes from freezing. This product is also sold in limited sizes through retail stores across North America.

Product Advantages

  • Available in a wide range of pipe sizes and thicknesses

  • Indoor Air Quality: Low VOC, fiber-free, non-particulating, formaldehyde-free insulation

  • ASTM E 84 25/50 / CAN ULC S102.2 rated

  • Reduces plumbing noise

  • Resists mold and mildew

  • Cost effective

  • Made in Canada

Application Areas

  • Domestic hot and cold water lines

  • Domestic heating and plumbing line

  • Acceptable for use on PEX

  • Acceptable for use with heat tracing/heat tape

Specifications

Dark gray flexible PE thermal insulation in tubular form with semi-slit perforation for easy opening

  • ASTM C-1427, Type 1

  • ASTM E 84 / CAN ULC-S102.2 1” 25/50

  • NFPA 90 A/B / Acceptable for use in duct/plenum applications

Sizes:

  • Wall thicknesses (nominal) 3/8”, ½”, ¾” and 1”

  • In sizes 3/8” to 4” IPS

  • Lengths: 6’ lengths (3’ lengths sold in some retail stores)

For complete Specification and R-Value details, download the product submittal sheet.

Accessories

  • ArmaFlex 520 and 520 Black Adhesive – Air-drying, solvent-based contact adhesive for strong bonds and tight seams.

  • AP ArmaFlex Insulation Tape

  • ArmaFlex Black LapSeal Tape

Armacell Manufacturing Locations

Did you know?

Armacell has 5 manufacturing facilities in the US and 1 in Canada. That means almost any product you order in North America is made in North America. Some exceptions apply.

Made In USA

2018 © Armacell LLC • 55 Vilcom Center Drive • Suite 200  • Chapel Hill, NC 27514 • tel 800 866 5638 • email: info.us@armacell.com